Bore Pump Not Working? Signs Your Bore Pump Needs Repair or Replacement

For many rural homes around Pukekohe, Waiuku, Tuakau, Hunua and the wider Franklin area, the bore pump is the heart of the house. It fills the tank, feeds the taps, keeps stock water flowing and keeps the garden alive. When it starts to fail, the signs usually appear days or weeks before the water stops completely. Knowing those signs can save you from a sudden no-water emergency — and from a bigger repair bill.

The signs your bore pump is struggling

Water pressure comes and goes — showers feel weaker, taps splutter, or pressure drops when a second tap opens.

Taps cough and splutter — air in the lines often means the water level, foot valve or pump is not working as it should.

The pump clicks on and off too often — a pump that starts and stops every few seconds is working too hard and will wear out fast. This is often linked to the pressure tank or pressure switch.

Water looks dirty or gritty — sediment, sand or discoloured water can point to a failing bore, a worn pump or a filter problem. Do not ignore a change in taste or smell.

Power bills creep up — if nothing else in the house has changed, a pump that runs longer to do the same job may be the cause.

Strange noises — a healthy system should be quiet in normal use. New grinding, humming or rattling sounds need checking.

Three simple checks you can do first

You do not need to open the pump or touch electrics. These three checks are safe and help you describe the problem clearly when you call:

  1. Check the power. Look at the breaker and check whether power to the pump has tripped. If it keeps tripping, leave it off and call a plumber — repeated tripping is a warning sign.
  2. Check the pressure. Note whether the pressure gauge (if you have one) sits in its usual range, and whether it moves when a tap opens.
  3. Check for leaks. Walk to the tank and bore area. Look for leaks, wet ground, a running tap, a split pipe or a stock trough valve stuck open. A small leak can make a good pump look faulty.

Please do not pull the pump out of the bore yourself. Bore pumps are heavy, wired in, and easy to damage. Dropping a pump or a tool into the bore can turn a repair into a much bigger job.

Repair or replace — how do you decide?

Repair makes sense when the fault is in the pressure switch, pressure tank, wiring, foot valve or a blocked filter, and the pump itself is still sound. Replacement usually makes sense when the pump is old, the motor is burnt out, output has fallen a long way, or the same fault keeps coming back. A good plumber should test the pump, the electrics and the water delivery before recommending either option — and explain the cost of both, so you can decide.

Age matters, but condition matters more. A well-fitted pump on clean water can last many years. A pump that has been cycling on and off, pumping sand, or running dry will not last as long, even if it is not very old.

How to make your next pump last longer

Service the pressure tank and switch — they protect the pump from short cycling.

Keep filters clean and replace them on schedule.

Fix leaks quickly, even small ones at troughs and garden taps.

After storms or power cuts, check that the system restarts normally.

Keep a note of the pump model and install date — it saves time on every future job.

No water, low pressure or a pump that will not stop? Call Montgomery Plumbing on (09) 2927 505. Third-generation Franklin plumbers — we service and replace bore pumps across Pukekohe, Waiuku, Tuakau, Karaka, Drury, Bombay, Hunua and Awhitu.

 

Leave a Comment

Your email address will not be published. Required fields are marked *